Lenovo ThinkPad X230 Tablet User Manual page 78

2. Apply light pressure and swipe your finger across the reader in one smooth motion.
Logging on to the system
After you enroll your fingerprint, log on to the system by doing the following:
1. Set a Power-on password or a Hard disk security, or both.
2. Turn your computer off and then on again.
3. When prompted, swipe your finger over the reader.
4. On request, type your power-on password, your hard disk password, or both. The enrolled fingerprint is
now associated with your power-on password, your hard disk password, or both.
The next time you start the computer, you can log on to the system by swiping your finger over the
reader once.
Attention: If you always use your fingerprint to log on to the system, you might forget your password. Write
down your password, and keep it in a safe place. If you forget it and for some reason you cannot swipe
your finger across the reader, for example, if you injure that finger, you cannot start the computer or change
the password.If you forget your power-on password, you must take your computer to a Lenovo authorized
servicer or a marketing representative to have the password canceled.
If you forget your hard disk password, Lenovo cannot reset your password or recover data from the hard
disk. You must take your computer to a Lenovo authorized servicer or a marketing representative to have the
hard disk drive replaced. Proof of purchase is required, and a fee will be charged for parts and service.
Setting the fingerprint reader
If you want to change the settings of the fingerprint reader, follow the procedure below.
The fingerprint submenu under the Security menu of the ThinkPad Setup offers the following choices:
• Predesktop Authentication: Enables or disables fingerprint authentication before the operating system
is loaded.
• Reader Priority: Defines the priority for fingerprint readers if an external fingerprint reader is attached.
• Security Mode: Specifies the settings of the security mode.
• Password Authentication: Enables or disables password authentication.
Note: This item appears if High security mode is selected.
• Reset Fingerprint Data: By choosing this item, you erase all of the fingerprint data stored in either the
internal or external fingerprint reader.
To set an item in the fingerprint submenu:
62
User Guide