Table of Contents
Advertisement
MACRO RECORDING
Use the macro function when recording a small object from close-up position: You can shoot the
subject as close as approximately 2 cm from the lens surface, magnifying the image to fill the screen.
1
Aim the DVD video camera/recorder at the
subject, and press the zoom lever to "W"
control side.
RECORDING SUBJECTS FOR STRONGER WIDE-ANGLE OR TELEPHOTO
EFFECT
Use the tele-conversion lens or wide-conversion lens with the following filter diameter and thread
pitch to record subjects for stronger telephoto or wide-angle effect:
Filter diameter: 34 mm for DZ-GX20E, DZ-MV750E or DZ-MV730E; 30.5 mm for DZ-MV780E
Thread pitch: 0.5 mm
When attaching the optional DZ-TL1 tele-conversion lens or DZ-WL1 wide-conversion lens, use the
optional step-up ring: DZ-SR3437 for DZ-GX20E, DZ-MV750E or DZ-MV730E, DZ-SR3037 for DZ-
MV780E (see page 148).
1
Remove the lens hood from DVD video
camera/recorder, and attach the step-up ring
over the lens.
Lens hood
(Remove)
• Tele-conversion lens:
• Wide-conversion lens: For stronger wide-angle effect
:
Note
• Be careful not to lose the removed lens hood.
• With DZ-TL1 tele-conversion lens, the focusing range
at "T" (telephoto) control side is between approx. 5 m
and infinite.
• When a conversion lens is attached, note that the four
corners of screen will be slightly dim if you zoom in on
a subject on the W control side (wide-angle side).
• When replacing the lens, take care not to drop the
DVD video camera/recorder.
• Attaching the conversion lens will disable the function
of the built-in flash (for DZ-GX20E only): Specify
"Flash: Off" (see page 78).
• If a generally available filter is attached, do not attach
the removed lens hood.
60
For stronger telephoto effect
:
Note
• Zoom can be used, but the subject may not be
focused, depending on the distance to the subject. In
this case, move the zoom to "W" control side to focus.
• The amount of light tends to be insufficient during
macro recording: If the subject image is too dark, use
additional lighting.
2
Remove the cap of conversion lens, and screw
the lens into the thread of step-up ring.
Conversion lens
Step-up ring
(Attach)
Advertisement
Table of Contents
