Functions And Features; Tuner Section - Hitachi CX-45E User Manual

FUNCTIONS AND FEATURES

TIMER AND CLOCK
SLEEP TIMER
Refer to page 75 for illustrations.
Pressing SLEEP [16] sets the unit to Standby mode at desire timer setting.
TIMER-PLAY/TIMER-RECORDING
The programmable timer turns on and off your desired sound source at your desired time. It can
also start recording from a radio broadcast at your desired time.
SETTING THE CLOCK
Refer to page 75 for illustrations.
1. Make sure the unit is in Standby mode. Press the PROG. MEM/CLOCK button [21] once.
2. Adjust the hour setting by pressing 4/1 button [20] or ¡/¢ button [19] until it reaches the
desired hour.
3. Press the PROG. MEM/CLOCK button [21] again.
4. Adjust the minute setting by pressing 4/1 button [20] or ¡/¢ button [19] until it reaches the
desired minute.
The clock will commence time keeping at the last press of the 4/1 button [20] or ¡/¢ button [19].
Pressing the 4/1 button [20] or ¡/¢ button [19] during this time will reset the clock's timing again.
After 10 seconds, the display will stop blinking. The time is now set.
To reset or adjust time again, please perform steps 1-4.
SURROUND SOUND AND BASS BOOST FEATURES
The Surround Sound feature provides enhanced four speaker output and extra wide stereo separa-
tion. The BASS BOOST feature provides extra Bass Response, especially at lower volume levels.
• Press the SURROUND button [25] to select this function. The Surround Indicator lights up. Press
again to turn off. The Surround Indicator light will go off.
• Push the BASS BOOST button [12] to "ON" _ to obtain rich Bass sound as desired.
NOTE: If you are playing music with heavy Bass sound at loud volume levels, you may experience
distortion if the BASS BOOST feature is "ON" _. If this occurs, reduce the volume or switch the
BASS BOOST feature "OFF" —.

TUNER SECTION

TUNER AERIALS
• For FM, extend the telescopic aerial. To improve FM-reception, incline and turn the aerial. Re-
duce its length if the FM-signal is too strong (very close to a transmitter).
• For AM, the set is provided with a built-in aerial, so the telescopic aerial is not needed. Direct the
aerial by turning the whole set.
STEREO/MONO (FM only)
• When an FM stereo signal is too weak or noisy for stereo listening, set the switch [33] to the
MONO position to reduce the noise.
TUNER with PRESET STATIONS
• Allows you to memorize 20 stations for FM and 20 stations for AM.
21
English