Focusrite TrakMaster Pro Manual page 9

Installing digital card
The digital card is mounted in place using the digital connector fixings and the two
plastic support pillars, which should be fitted to the module base using the two
crosshead screws supplied.
1. Place module on a flat clean surface with the bottom facing uppermost and offer
the two crosshead screws supplied to the two countersunk holes in the base, using a
small piece of adhesive tape to secure the head of the screw to the bottom surface
of the module.
2. Place module top uppermost and from the inside of the module place the two
plastic support pillars over each screw.
3. Now offer the digital card from the rear of the module, lining up the screws from
the base with the two holes in the card, and secure it in place with the two Nyloc
nuts supplied.
4. Using the two screws that secured the original blanking panel, secure the digital
card to the rear panel.
5. Plug in the 10-way cable to J6 on the main
adhesive tape from the base of the module.
6. Remove links J3, J4, J5 and J6 as shown below:
Selecting for Professional or Consumer Use
This link determines the SPDIF output level for use with various Professional and
Consumer products. Please consult your recording product/soundcard manual to
determine which setting is appropriate for your system.
circuit board, and remove the
9