Setting The Sample Rate And Synchronising To The S/Pdif In - Focusrite Saffire LE User Manual

Setting the Sample Rate and Synchronising to the S/PDIF In

The bottom right of the SaffireControl LE GUI displays the sample rate and allows it to be selected. To
set a sample rate, simply click on the LED beside it, which will illuminate once selected. If the Saffire LE
is currently being used to record then a sample rate cannot be selected and IN USE will be illuminated,
as follows:
If wanting to synchronise to an external source (via the S/PDIF In signal), which is normally advisable when
recording a S/PDIF signal, then press the EXT LED, which will illuminate once selected. Saffire LE will only
be correctly synchronised to this source if LOK is illuminated next to it. If not, make sure that the sample rate
of the incoming S/PDIF signal is the same as the one set in this window.
Click on LED next to
value to select that sample rate
EXT sync switch –
engage to lock Saffire LE
to its S/PDIF In
This illuminates when the sample
rate can't be changed as the Saffire
is in use with a session
This illuminates when the Saffire LE
is correctly synchronised