Range Hood Use; Range Hood Controls; Range Hood Care; Range Hood Lamps - KitchenAid KHTU105RSS1 Installation & Use Manual

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the right-hand underside of the
range hood.
C
B
A. Controls
B. Light switch
C. Blower switch
D. Blower speed switch

Range Hood Controls

Operating the light
1. Move the light switch to the "1" position to turn range hood
light ON.
2. Move the light switch to the "0" position to turn range hood
light OFF.
Operating the blower
1. Move the blower switch to the "1" position to turn the blower
ON. The blower will begin operating at the speed set on the
blower speed switch.
2. Move the blower switch to the "0" position to turn the blower
OFF.
Adjusting the blower
Depending on your model, the blower has either 2 or 3 speed
controls. Move the blower speed switch to "1" position for low
speed, "2" position for medium speed (or high speed on some
models), or "3" position for high speed.
A
D

RANGE HOOD CARE

Range Hood Lamps

Replacing a Halogen Lamp
This hood uses four 12-volt, 20-watt halogen lamps.
Turn off the range hood and allow the hallogen lamps to cool.
To avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb using tissue or
wearing cotton gloves to handle bulb.
To Replace:
1. Disconnect power.
2. Remove 2 screws from the circular metal trim around the
lamp assembly.
3. Pull the trim and lamp assembly down far enough so that the
lamp can be pulled out of the socket clips.
A
A. Remove 2 screws.
B. Pull trim with lamp assembly down.
4. Insert the new lamp into the socket clips and push the lamp
assembly back up into the hood.
5. Replace the screws.
6. Reconnect the power.

Cleaning

Exterior surfaces:
To avoid damage to the exterior surface,do not use steel wool or
soap-filled scouring pads. Rub in direction of the grain line to
avoid scratching the surface.
Always wipe dry to avoid water marks.
Stainless Steel Cleaner and Polish.
Mild liquid detergent and water.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Filters:
For vented installations, use 2 hands to remove filters. Turn the
knob to the left (counterclockwise) to release filter. Repeat with
other filter.
A
B
9