Door Swing Dimensions; Anti-Tip Requirements; Tipping Radius - KitchenAid KSSS36DAW00 Installation Instructions Manual

Door swing dimensions
I
!W=A
115"= B
137"=C
Front of refrigerator
90"= D
115"= E
137"= F
Tipping radius
I' ,
, I
,
>'
I'
#'
I'
:
:
:
:
Forward/backward ----*I-
-*--
tipping radius ,I**S
.'
a'
em----_
Side
//
c4--
tipping radius ,=/
/ /
/
87-l /4" (222 cm)
90-l/1 6" (229 cm)
92-5/8" (235 cm)
87-l /4" (222 cm) 95-l /2" (243 cm)
Location must permit doors to open to
90" min. Allow 1 inch (2.5 cm) min. space
between refrigerator side and corner wall.
Anti-tip requirements
l/4" (6
mm)
2" (5 cm) --%pe
min.
1
Two, 2" x 4" x
32" (5 cm x
. *
10 cm x 81 cm)
anti-tip wood
boards
Attach to wall
studs with six,
#8x 3" (76 mm)
(or longer)
wood screws.
Boards must be
- long enough to
fully cover
width of
compressor
cover.
+ rear
wall
If boards are placed before installation of
refrigerator, locate boards so the bottom surface of
the boards are 84 inches (213 cm) from the floor.
During installation, raise the refrigerator up so there
is l/4 inch (6 mm) maximum between top of
refrigerator and bottom of anti-tip boards.
If solid soffit is 1 inch (2.5 cm) above
refrigerator, anti-tip wood boards are not required.
If solid soffit is not available or soffit is more than
1 inch (2.5 cm) above cover, center wood boards
on rear wall l/4 inch (6 mm) maximum above
refrigerator. Attach wood boards to wall studs with
wood screws - making sure that screws are
engaged in wall studs l-l /2 inch (3.8 cm) minimum
and that boards extend 2 inches (5 cm) minimum
over the top rear of refrigerator compressor cover.
Page 4