Replacement Keys; Sentry Key Programming - Chrysler Sebring Owner's Manual

2009
Hide thumbs Also See for Sebring:
Table of Contents

Advertisement

All of the keys provided with your vehicle have been
programmed to the vehicle electronics.

Replacement Keys

NOTE: Only keys that have been programmed to the
vehicle electronics can be used to start the vehicle. Once
a Sentry Key has been programmed to a vehicle, it
cannot be programmed to any other vehicle.
At the time of purchase, the original owner is provided
with a four-digit Personal Identification Number (PIN).
The PIN is required for authorized dealer replacement of
keys. Duplication of keys may be performed at an
authorized dealer or by using the Customer Key Pro-
gramming procedure. This procedure consists of pro-
gramming a blank key to the vehicle electronics. A blank
key is one which has never been programmed.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
NOTE:
When having the Sentry Key Immobilizer
System serviced, bring all vehicle keys with you to the
authorized dealer.

Sentry Key Programming

You can program new keys to the system if you have two
valid Sentry Keys by performing the following proce-
dure:
1. Cut the additional Sentry Key Transponder blank(s)
to match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch. Turn
the ignition switch to the ON position for at least three
seconds, but no longer than 15 seconds. Then, turn the
ignition switch to the LOCK position and remove the first
key.
3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the ON position within
15 seconds. After ten seconds, a chime will sound. In
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sebring 2009

Table of Contents