Changing The Light Bulb; Vacation And Moving Care - KitchenAid KUIS155HBL0 Use & Care Manual

Changing the Light Bulb

The ice maker has a light bulb in the top of the storage bin.
To replace it, open the bin door and follow these
instructions:
1. Unplug ice maker or disconnect power.
2. Remove the three screws that hold the cutter grid
cover in place. Reach behind the control panel and pull
the light bulb down from the ceiling.
3. Replace with a 12-volt wedge base-type bulb
(automotive #917). Locate the light bulb receptacle in
the ceiling behind the control panel. Align the flat edge
of the light bulb with the receptacle and snap the bulb
into place.
4. Replace the cutter grid cover with three screws.
5. Plug in ice maker or reconnect power.

Vacation and Moving Care

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
To shut down the ice maker:
1. Unplug ice maker or disconnect power.
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove the two screws in the lower access panel and
the two screws from the base grille area of the front
panel support. Pull forward to remove the lower access
panel.
5. Disconnect the inlet and outlet lines to water valve.
Allow these lines to drain and then reconnect to the
valve.
6. Replace lower access panel and screws. Drain water
from water pan by removing the drain cap. Also,
remove water from drain line.
7. Before using again, clean the ice maker and storage
bin.
8. Plug in ice maker or reconnect power.
NOTE: All components of the ice maker are permanently
lubricated at the factory. They should not require any
additional oiling throughout the normal life of the machine.
15