Changing The Light Bulb; Vacation And Moving Care - KitchenAid KUIS185JBL1 Use & Care Manual

Changing the Light Bulb

The ice maker has a light bulb in the top of the storage bin. To
replace it, open the bin door and follow these instructions:
1. Unplug ice maker or disconnect power.
2. Remove the three screws that hold the cutter grid cover in
place. Reach behind the control panel and pull the light bulb
down from the ceiling.
3. Replace with a 12-volt wedge base-type bulb (automotive
#917). Locate the light bulb receptacle in the ceiling behind
the control panel. Align the flat edge of the light bulb with the
receptacle and snap the bulb into place.
4. Replace the cutter grid cover with three screws.
5. Plug in ice maker or reconnect power.

Vacation and Moving Care

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
To shut down the ice maker:
1. Unplug ice maker or disconnect power.
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove the two screws in the lower access panel and the
two screws from the base grille area of the front panel
support. Pull forward to remove the lower access panel.
1. Lower Access Panel Screws
2. Base Grille Screws
5. Disconnect the inlet and outlet lines to water valve. Allow
these lines to drain and then reconnect to the valve.
6. Replace lower access panel and screws.
7. Drain water from water pan by removing the drain cap.
8. If the room temperature will drop below 32°F (0°C), remove
water from the drain line.
For ice makers with a drain pump installed:
Plug in ice maker or reconnect power.
Turn ice maker off and remove all remaining ice from ice
bin.
Pour 1 quart (0.95 L) of water into the ice bin near the
drain and let the unit stand for approximately five
minutes. This will allow the water in the bin to drain into
the drain pump so that the pump will remove the
remaining water from the ice bin and the drain pump.
Unplug ice maker or disconnect power.
9. Before using again, clean the ice maker and storage bin.
10. Plug into a grounded 3 prong outlet.
NOTE: All components of the ice maker are permanently
lubricated at the factory. They should not require any additional
oiling throughout the normal life of the machine.
11