Connecting The T1/E1 Wan Ports; 68-Pin Scsi To 8 Rj-45 Connectors Cable; Scsi-To-Rj45 6-Foot Wan Cable - Patton electronics 2616RC User Manual

Model 2616RC T-DAC User Manual

Connecting the T1/E1 WAN ports

An active T1/E1 is not necessary to configure the T-DAC. However, active T1/E1 connections are required when
mapping WAN time slots to other WAN time slots. The factory-set default configuration of the Model 2616RC
has the T1/E1 ports disabled.
The following types of cables can used to connect the 2616RC to T1/E1 lines:
• 68-pin SCSI to 8 RJ-45 connectors cable, 6 foot (1.8 m) (part #10-3096TM68/8RJ45-6) (see section
pin SCSI to 8 RJ-45 connectors cable"
• 68-pin SCSI to 16 RJ-45 connectors cable, 6 foot (1.8 m) (part #10-3096TM68/16RJ45-6) (see section

"68-pin SCSI to 8 RJ-45 connectors cable"

• 68-pin SCSI to open end, 12 foot (3.6 m) (part #10-3096TM68-12) (see section
cable" for installation details)

68-pin SCSI to 8 RJ-45 connectors cable

The SCSI-to-RJ-45 cable (see
the other end of the cable, T1/E1 lines terminate on 8 or 16 individual RJ-45 connectors (wired as RJ-48C)
(see figure 9). Each RJ-45 terminated T1/E1 line connects directly to a local patch panel or to another
T1/E1 device.
Cable installation
for installation details)
for installation details)
figure 9) connects to the 2616RC via a male SCSI connector (see
Figure 9. SCSI-to-RJ45 6-foot WAN cable
2 • Hardware installation
"68-pin SCSI to open end
figure 10). At
"68-
24