Craftsman 919.155350 Owner's Manual page 8

.......... i iii, iiiii iiii i
TROUBLESHOOTING GUIDE
iii iiii ii ii Nil, IIIII
PROBLEM CAUSE
Gun too far from surface.
Thin, sandy coarse finish dry-
ing before it flows out°
Thick dimpled finish "orange
peeL" Too much material
coarsely atomized_
Too much air pressure
Improper thinner.
Gun too close to surface.
Air pressure too low.
Improper thinner.
Material not thoroughly mixed.
Surface rough, oily, dirty.
iiiiiiiiiiiii ii ii i i illll ,111111111 _ i
CORRECTION
Move gun closer to surface. See "Hints for Good
Spraying Results'L
Reduce pressure.
Follow paint manufacturer's instructions.
Move gun away from the surface. See "Hints for
Good Spraying Results"°
Increase air pressure or reduce fluid pressure.
Follow paint manufacturer's instructions.
Mix thoroughly
Properly clean and prepare surfaceo