Related Manuals for Euro-Pro RECTRACTOR IR577P
Summary of Contents for Euro-Pro RECTRACTOR IR577P
- Page 1 OWNER’S MANUAL Model: IR577P 120V., 60 Hz., 1700 Watts EURO-PRO Operating LLC U.S.: 94 Main Mill Street, Door 16 Canada : 4400 Bois-Franc Plattsburgh, NY 12901 St-Laurent, QC H4S 1A7 Tel. : 1 (800) 798-7398 www.euro-pro.com.com...
-
Page 2: Important Safety Instructions
Doing so will The liability of EURO-PRO Operating LLC is limited solely to the cost of the repair or replacement scratch and/or damage the surface. of the unit at our option. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes. -
Page 3: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE REASONS & SOLUTIONS • Iron should be plugged into a 120V AC electrical outlet only. Iron does not heat Make sure that the plug is securely in the socket. • Fabric/temperature setting too low. Select a higher fabric/temperature setting. -
Page 4: Ironing Chart
Do not allow plug to whip when rewinding. IRON LED Display Panel NOTE: iron delicate fabrics, it is best to first test the temperature of the iron on a hem or an inside seam. DIRECTIONS ON LABEL FABRIC STEAM... - Page 5 6. If the iron has not been used for a few 1. Set the variable steam control to weeks, hold the iron horizontally and any steam position.
- Page 6 OPERATING INSTRUCTIONS 4. Place the iron on its heel on a stable, protected surface and allow the iron to heat for approximately two (2) minutes or until the temperature Slide settings on the right side of the LED display panel have stopped flashing.
Need help?
Do you have a question about the RECTRACTOR IR577P and is the answer not in the manual?
Questions and answers