Lubrication; Maintaining Your Table Saw - Craftsman 113.221740 Owner's Manual

Maintaining Your Table Saw (continued)
Lubrication
The saw motor bearings and gear case have been
packed at the factory with proper lubricant and require no
additional lubrication_ The following parts should be oiled
occasionally with SAE no. 20 or' no. 30 engine oil,
l r Elevation screw threads and pivot nuL
2_ Elevation bracket pivot points,,
3. Bearing points in blade guard, miter gauge and rip
fence assemblies (as shown by*)=
Miter Gauge _ _ Assembly
Ass_ v I,-d
Assembly
Sears Recommends the Following Accessories
Item Cat. No.
Saw Blades ................................................................... See Catalog
DadoiMolding Head Insert ........................... ',........ 9-29971
5-5/8" Molding Head ........................................................... See Catalog
6" Dado Set ................................................. See Catalog
WARNING: Do not use adjustable (wobble) type
dados or carbide tipped dado blades on this saw.
Maximum dado width is 9116 inch.
Steel Leg Set ............................................................... 9_22235
Caster' Set .............................. i ............... 9-22222, 9-22221
Sears may recommend other accessories not listed in
manual.
See your nearest Sears Store or Power and Hand Tool
Catalog for other accessories.
Do not use any accessory unless you have received
and read complete instructions for its use.
I WARNING: Use only accessories_recommended for J
this saw. Using other accessories may be danger `=
OUS.
34