Table of Contents
Advertisement
Mounting TableSaw to Workbench,Cabinetor Legset(continued)
Workbench Mounting Using "C" Clamps
An alternative method of securing your table saw is to
fasten the saw base with "C" clamps._
1. Follow instructions
for mounting to workbench, substi-
tutirig "C" clamps in each recessed mounting screw
Iocation_
2. Securely clamp saw to workbench
using three or four
"C" clamps, as shown.
Supporting surface where saw is to be mounted should
be examined carefully after mounting to insure that no
movement can occur during use.. If any tipping, sliding or
walking is noted, secure the workbench
or cabinet before
operating the table saw.
Cabinet
or Legset
Mounting
Using
Hardware
When mounting table saw to a cabinet or tegset and using
a vacuum hookup, holes should be drilled through a 3/4"
thick plywood base using the dimensions illustrated.
When mounting table saw without a vacuum hookup to
the base, an opening must be made in th_ plywood base
using the dimensions
illustrated, so the sawdust can fall
away from the saw base area.
WARNING: Never clamp the table saw directly to a l
legset. The saw could fall. You could be badly cut.
Table Saw Mounting and Assembly Procedures
1_Locate the proper hole mounting
diagram for your
desired type of table saw mounting.
2_ Mark the hole locations and cutout opening if vacuum
is not used. Drill the holes and cutout the area to allow
sawdust to fall away from the base if a vacuum is not
being utilized
3. Place the table saw on the mounting surface and align
the four holes..
4. insert four (4) 1/4-20 screws that are long enough for
washers and nuts which will properly secure the table
saw to the mounting surface.
Table Saw Mounting
to Legset
Accessory,
Cat. No, 9-22235
1. Be sure to mount the table _
to the 3/4" thick .p._-
_for
mounting table saw to Iegset as shown
in the previous diagram..
2. Assembie
legs
and stiffeners
per legset 9-22235
instructions using the hole pattern marked "B" in the
side stiffeners_
3o Place the table saw with plywood base on legset and
align the four holes_
4_ Insert tour (4) 1/4-20 screws that are long enough for
washers and nuts which wilt properly secure the table
saw to the legset. Tighten hardware..
When using a table extension on any side of the saw, bolt
the saw to a stationary surface or' prep up the outer end
of the extension from the floor or bench top to keep the
saw from tipping
"C" Clamps
(Front and Rear)
Recessed Mounting
Screw Location
Diagram of Clamping
Table Saw to Workbench
3/8" Dia.
16-1/8"
11-1/4"
21 "
Opening-
if vacuum
is not
used
16-9/16"
_
2"
(Front of Table
Saw)
Diagram
of Cabinet or Legset
Mounting
Holes
_These
holes
used for legset
9-22235
Hide quick links:
Advertisement
Table of Contents
