Cord Storage; Removing Vac From Storage Rack - Craftsman 113.179255 Owner's Manual

Assembly (continued)
4. Align the upper hook on the Vac with the
rectangular opening in the storage rack.
Push the Vac against the storage rack.
Storage n
Rack t l
\ _ I Release Tab
\ __Depressed
Retangular _1
Opening
in I _ _
Storage _, _
Rack ---------_ E] _ -q
Upper __
Vac ,F41 _ I
Push Vac I I I
Against L I J
Storage _[, ,_'
Rack I \
I II hvac
1% i Drum
5. Lower the Vac until the upper Vac hook
and lower hook are engaged and the
bottom of the Vac drum rests on the
rack. The release tab will pop out over
top of Vac.
_/Release Tab
Upper
Vac Hook\
Lower
Vac Hook_
6. Snap the power cord into the cord
retainers in the front surface of the rack
and loop around the cord keeper
behind the wand storage area.
The cord may exit on either the left or
right side. Plug the power cord into the
electrical outlet. Do not fasten power
cord to wall in any way.
j Cord
#_Keeper
Cord
Cord Storage
When your Wet/Dry Vac is not in use,
it should be unplugged from the outlet.
Excess cord should be wrapped over the
hose storage rack and around the
accessory storage bin. Several loops may
be required to eliminate any tripping
hazard created by a loosely hanging
cord.
Removing Vac from Storage
Rack
1. With your right hand, raise the folding
handle.
2. With your left hand depress the release
tab located on the upper left corner of
the storage rack.
3. Lift up on the handle, and pull the Vac
up and out of the storage rack.