Surface Units; Lift-Up Cooktop; Drip Pans - GE JDS28 Owner's Manual

Hide thumbs Also See for JDS28:
Table of Contents

Advertisement

ge.com
Be sure the controls are turned to OFFand the surface units are cool before attempting to remove them.
_ Drip
Cooktop
tab
rim
When properly seated, the locking
tab should lock onto the cooktop rim
through the notch in the drip pan.
Surface Units
To clean the surface
units, turn the
control
to the highest
setting for a
minute.
The coils will burn off" any soil.
Toremovea surfaceunit:
To remove the drip pans for cleaning,
the surface units [_lttst be removed first.
[]
Push the surface unit back toward
the receptacle to fiee the locking
mb fiom the cooktop.
Toreplacea surfaceunit:
%
[]
Replace the chip pan into the recess
m the cooktop. Make sure the
opening in the pan lines up with
the receptacle.
Insert
the terminals
of the surface
unit through
the opening
in the
drip pan and into the receptacle.
Locking tab
Receptacle
I,ifl the surface unit about 1 inch
above the drip pan and pull it out.
Do not lift the surfaceunit more than I inch.
If you do, it may not lie flat on the drip pan
when you plug it back in.
NOTE." R epeated lifting of the surface unit
more than 1 inch above the drip pan can
permanently
damage the receptacle.
_]
Push the surface unit in and down
to lock the tab in place so it rests
evenly in the cooktop.
Donotimmerse thesurfaceunitsin liquidsof
an}/kind.
Donotcleanthesurface unitsin a dishwasher.
Donotbendthesurfaceunitplug terminals.
Donotattemptto clean,adjustor in an}/way
repairtheplug-inreceptacle.
Drip Pans
Remove the surface units. Then lift out
the ddp pans.
Place them in a covered container. Add
1/4 cup ammonia and let soak several
hours or overnight. Wash, rinse well
and dtT:
The drip pans may also be cleaned in
a dishwasher.
Clean file area under file drip pans
often. Built-up soil, especiaUy gnease,
may catch fire.
Donot coverthedrippanswith foil. Using foil so
closeto thereceptacle couldcause shock, f ire or
damageto therange.
Supportrod
Be sure all surface units are turned
off before raising the cooktop.
Lift-Up Cooktop
Cleantheareaunderthecooktop often.Built-up
soil,especially grease, m aycatchfire.
To make cleaning
easier; the entire
cooktop
may be lifted up and supported
in the up position.
Be sure aU the surface units are unned
off before rMsing the cooktop. The
surface units and drip pans do not need
m be removed; however; you m W remove
one m make raising file cookmp easier.
A support rod will hold the cooktop tap
while you clean underneath
it.
After cleaning under die cookmp Mth
hot, soapy water and a clean cloth, lower
the cooMop. Be carefltl not m pinch
your fingers.
17

Advertisement

Table of Contents
loading

Table of Contents