GE JDS28 Owner's Manual page 19

ge.com
Possible Causes What To Do
Oven temperature too Oven thermostat * See the Adjust the oven thermostat--Do it yourself!
hot or too cold needs adjustment, section.
Oven willnot work Plug on range is not • Make sure electrical plug is plugged into a live,
completely inserted in properly grounded outlet.
the electrical outlet.
A fuse in your home may • Replace the fl_se or reset the circuit breakeL
he blown or the circuit
breaker tripped.
Oven controls improperly set. • See the Using the oven section.
"Crackling" or This is the sound of the • This is normal.
"popping. sound
metal heating and cooling
during the cooking functions.
"F- anda number
You have a function
• Press the CLEAR/OFF pad. Put the oven back into
or letter" flash error code. operation.
in the display
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the flmction
error code repeats, call for service.
Display flashes "bAd" The installed connection • Contact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone
is miswired.
Display goes blank
A fuse in your home may be • Replace the fi_se or reset the circuit breakeL
blown or the circuit
breaker tripped.
The clock is turned off from • See the Using the clock end timer section.
showing in the display.
Display flashes
Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be pressed
display
to
show "SF"
not pressed properly, at the same time and held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by pressing
the CLEAR/OFF pad, setting
the clock
and resetting any cooking fimction.
79