Advertisement
Laser Aperture Label: AVOID
EXPOSURE: Laser radiation
is
emitted from this aperture. (Fig. Y)
AVOID EXPOSURE
Laser radiation A
|
is emittedfrom/_.\
JL
this aperture _V
Fig. Y
Laser Warning Label
Laser Aperture
Label
Fig. Z
blade
laser be'_am "workpiece /
_k,,,_,
cutting line
top view
SLIDING THE REAR EXTENSION
[_,
WARNING]
To avoid possible personal injury
or damage to the miter saw due to
tipping, do not operate the saw without
the Rear Extension Support Bar.
Loosen the two screws (1) and extend
the rear extension support bar (2) by
sliding it out to match position, tighten
the two screws.
o NOTE: All the adjustments for the
operation of this machine have
been completed at the factory. The
Fig. AA
laser guide is calibrated and set up
to project to the left of the blade.
(Fig. Z)
o CAUTION-Use
of controls or
adjustments or performance of
procedures other than those
specified
herein may result in
hazardous
radiation
exposure.
o CAUTION=The use of optical
instruments with this product
will
increase eye hazard.
o Do not attempt to repair or
disassemble
the laser. If
unqualified
persons attempt to
repair this laser product,
serious
injury may result. Any repair
required on this laser product
should be performed
by authorized
service center personnel.
27
Advertisement
