Advertisement
Fig. I
1Mtersaw ase
2. Hex head bolt
3. Rubber washer
_
,,
4. Flat washer
1-
[
i[
5. Work surface
5 -mL-
: ',
6. Flat washer
|
,,
7. Lock washer
_
8
6
8. Hex nut
9. Jam nut
7
NOTE: Mounting hardware is not
included with this tool. Bolts, nuts,
washers and screws must be
purchased separately.
.
For portable use, place the
saw on a 3/4 in. thick piece of
plywood. Bolt the base of the
miter saw securely to the plywood
using the mounting holes on the
base. Use C-clamps to clamp this
mounting board to a stable work
surface at the worksite. (Fig. J)
Removing
Blade
1. Unplug the saw from the outlet.
2. Raise the miter saw to the upright
position.
3. Loosen the lower cover plate screw
(1) and the upper cover plate screw
(2) using a Phillips screwdriver.
NOTE: Do not remove the two
screws.
4. Rotate the cover plate (3) and blade
guard (4) to expose the arbor bolt
(6-Fig M).
5. Place the blade wrench over the
arbor bolt.
Fig. K
Fig. J
REMOVING AND INSTALLING
THE
BLADE
(FIG. K, L, M)
WARNING
I
Do not use a blade larger than 12 in.
in diameter.
To avoid injury from
an accidental
start, make sure the
switch is in the OFF position
and the
plug is not connected
to the power
source outlet.
.
8.
Locate the arbor lock button (5) on the
motor, below the belt cover. (Fig. L)
Press the arbor lock, holding it
in firmly while turning the blade
clockwise. The arbor lock will
engage after turning the wrench.
Continue to hold the arbor lock
while turning the wrench clockwise
to loosen the arbor bolt.
Fig. L
5
Advertisement
