Advertisement
INSTALLING THE DUST BAG (FIG. D)
1. Install the dust port elbow (3) on the
dust port located in the back of the
saw head, behind the motor.
2. Place the dust bag neck opening
around the dust port elbow (3), and
release the metal collar.
Fig. D
3
Fig. F
2
,_o_,_
o-
'.i I
_7_
....
To empty the dust bag (2), squeeze the
metal collar (1) and remove from dust port
elbow. Open the zipper on underside of
the bag and empty into waste container.
NOTE: Check frequently and empty
bag before it gets full.
NOTE: A vacuum hose can be attached
to the saw dust port instead of the dust
bag and elbow.
INSTALLING THE SAFETY HOLD-
DOWN CLAMP (FIG. E, F)
1. Place the hold-down clamp assembly
(1) into one of the mounting holes (2)
located behind the fence.
2. Thread the hold-down clamp knob
(3) into the hole (2) located at the
rear of the saw base.
3. Tighten the hold-down clamp knob (3).
Fig. E
SAW BLADE WRENCH (FIG. G)
For convenient storage and prevention
of loss, there is a clip (1) located at the
rear of the base for storing the blade
wrench (2).
Fig. G
REMOVING AND INSTALLING THE
TABLE INSERT (FIG. H)
[_
WARNING]
TO AVOID INJURY:
o Always
unplug the saw to avoid
accidental
starting. Remove all
small pieces of material from
the table cavity underlying
the
table insert before performing
any cuts. The table insert may
be removed for this purpose,
but always re=attach the table
insert prior to performing
a
cutting
operation.
Advertisement
