Assembly; Tools Required For Assembly; To Remove Edger/Trimmer From Carton; To Assemble The Edger/Trimmer - Craftsman 536.797470 Owner's Manual

_'/V_ CAUTION: Always wear safety
glasses or eye shields while assembling
Edger!Trimmer,
TOOLS REQUIRED FOR ASSEMBLY
2 - 1/2 inch Wrenches
(or adjustable wrench)
2 - 9/16 inch Wrenches
(or adjustable wrenches)
2 - Adjustable Wrenches
1 - Regular Screwdriver
1- Pliers
Upper
Handle
Lever
Rod
The figure to the right shows the Edger/
Trimmer completely assembled,
References to the right or left hand side
of the Edger/Trimmer are from the view-
point of the operator's position behind the
unit,,
TO REMOVE EDGER/'[RIMMER
FROM CARTON
. Remove the lower handle, control rod,
upper handle and packing material from
the carton.
• Remove wheels, parts bags and packing
material from the carton.
• Cut down all four corners of the carton,
• Remove packing material from around
Edger/Trimmer blade.
TO ASSEMBLE THE EDGER/
TRIMMER
NOTE: Lower handle shouldbe attached
first as it is difficult to attach lower handle
with the wheeis on.
- Place lower handle inside the Edger/
Trimmer frame as shown in top figure
and secure in place with four 5/1 6-18x
5/8 inch hex head wide flange screws
and four 5/1 6-18 hex head Iocknuts
found in parts bag. Hold back on the
lower handle as you tighten the screws,
Locknuts should be on the inside of the
frame as shown in middle figure of this
page°
• Attach the right rear wheel to the wheel
support rod of the Edger/Trimmer as
shown in lower figure on this page with a
1/2 x 3/4 inch flatwasher and cotter pin
found tn parts bag, Bend ends of cotter
pin,,
Handle
de
Handle
5116-18X 5/8 inch(_
Frame/
Lower Handle
!
5116-18)-_
/
-tHex Head ! ,
VIEW FROM RIGHT SIDE
Flatwasher Wheel _[
_
112x3/4 ' _ '
Pit
Cotter _