GE JSS26 Owner's Manual page 14

Careand cleaning oftherange.
If the range is removed for cleaning or any reason, make sure the chain is reattached.
J
Factory bra_
Backsehsh
ion some models)
Backof
range
Anti-Tip Device
%
Befbre placing range in the counter,
notice tt_e location of din stability
bracket which is already attached to
tt_e back of din range. This location
should work fbr most installations.
However, it may be more convenient
to hook tt_e stability chain to the unit
when tt_e stability bracket is attached
to tt_e upper set of holes in tt_e back
of range.
Theupperlevelset ofholesis intended for use
with a backsplash k it.If thebacksplash i s not
beingused,make surethatthereareno structural
supports for thecountertop whichwill interfere
with thestabilitybracket w henlocated in the
upper set of holes.
"_0 long screw
Washerand
[] Fasten one end of the smbilib_ chain
to the floor or wall with the long
screw and washer supplied.
/VOTE'. If attaching to masonrg, youcanbuy
suitable screwsandanchors a t hardware stores.
Usea masonry drill todrill therequired holes.
Chain
Washer'_i/!_
\\ \\\
Wall plate
Makecertainthescrewisgoingintothewall
plateat thebaseof thewallor oneof thestudsin
thebaseof thewall.
Whedmr you attach tt_e chain to tt_ewall
or floor, be certain flint the screw is in at
least 3/4 inch tt_ickness of wood odmr
than baseboard and that there are no
elecu'ical wires or plumbing in the area
which the screw could penetrate. Attach
tl_e smbili V chain in a location which will
allow tl_e chain m be in line with the
bracket side to aide as much as possible
when attached to tt_e unit. Test to see if
tl_e chain is securely f:astened by ragging
on tt_e chain.
%
@
Temporarily attach
the loose end of the
chain to the rear of
the countertop with
the tape fi'om the
packaging.
Place tt_e range in tl_e counter cutout
lemming just enough room between
the back of tt_e range and tt_e wall to
reach the stabilib_ bracket.
Hook the loose end of the chain
onto the bracket by slipping the
nearest link of tt_e chain into tt_e slot
in tt_e bracket. Make sure the chain is
pulled as tight as possible and that
dmre is no excess slack in the chain
_dter the chain is attached to tl_e
bracket.
%
Slide the range all the way back into
the cotmter. Once the range is
pushed back in place, there will be a
small amount of slack in the chain.
This is nomml.
CAUTION: E xcessive s lackin thechaincould
allowtherangeto tip over
The storage drawer may be
removed for cleaning under the
range.
14
Removable Storage Drawer
Thestorage draweris a goodplacetostore
cookware andbakeware. Donotstoreplastics
andflammable materialin thedrawer.
Do not overload the storage drawer. If din
drawer is too hem.y, it may slip offthe
track when opened.
To open dm drawer, _'asp the center of
the handle and pull straight out.
Toremove:
Pull the drawer straight out and lift over
the guide stops.
Toreplace:
Lift over the guide stops and slide the
(kawer into place.
To clean both the inside and the out.side:
Wipe _4th soap and water. Rinse well.
Donot usecleansing powdersorharsh
abrasives whichmayscratch thesurface.