Specifications - Craftsman 580.675610 Operator's Manual

EHGINETECHNICALIHFORMATION
This is a single cylinder, overhead vaive(OHV), air coded
engine, it is a low emissions engine.
In the State of California, Model Series 200000 engines are
certified by the California Air Resources Board to meet
emissions standards for 250 hours. Such certification does
not grant the purchaser, owner or operator of this engine any
additional warranties with respectto the performance or
operational life of this engine. The engine is warranted solely
according to the product and emissions warranties stated
elsewhere in this manual.
Power Ratings
* The gross power rating for individual gas engine models is
labeled in accordance with SAE (Society of Automotive
Engineers)code J1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002-05). Actual gross engine power will be lower
and is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Givenboth the
wide array of products on which engines are placed and the
variety of environmental issues applicable to operating the
equipment, the gas engine will not develop the rated gross
power when used in a given piece of power equipment
(actual "on-site" or net horsepower). This difference is due to
a variety of factors including, but not limited to, accessories
(air cleaner, exhaust, charging, cooling, carburetor, fuel
pump, etc.), application limitations, ambient operating
conditions (temperature, humidity, altitude), and engine-to-
engine variability. Due to manufacturing and capacity
limitations, Briggs & Stratton may substitute an engine of
higher rated power for this Series engine.
PRODUCTSPECIFICATJOHS
Generator Specifications
StartingWattage.................... 8600 Watts (8.6 kW)
Wattage .......................... 5600 Watts (5.6 kW)
AC Voltage.............................. 120/240Volts
AC Current
at 240 Volts ............................. 23.3 Amps
at 120 Volts ............................. 46.6 Amps
Frequency .......................... 60 Hzat 3600 rpm
Phase .................................. Single Phase
FuelCapacity............................ 5 U.S.gallons
Unit Weight .................................. 170 Ibs.
Engine Specifications
Gross* Horsepower ..................... 10 at 3600 rpm
Bore ................................ 3.12 in. (79 ram)
Stroke ............................... 2.44 in. (62 ram)
Displacement ........................ 18.64 in. (305 cc)
SparkPlug
Type: ............ Briggs & Stratton491055S or 5066D
SetGap To: .................... 0.030 inch (0.76 ram)
Armature Air Gap: .......... 0.008-0.012 in. (0.20-0.30 ram)
Valveclearance with valvespringsinstalled and piston1/4in.
(6 ram)pasttop deadcenter(checkwhenengineis cold).
Intake ................... 0.004-0.006 in. (0.10-0.15 mm)
Exhaust.................. 0.004-0.006 in. (0.10-0.15 mm)
Oil Capacity .................... 28 Ounces (0.8 Liters)
NOTE:For practical operation, the generator load should not
exceed 85% of rated wattage. Engine gross horsepower will
decrease3-1/2% for each 1,000 feet (300 meters) above sea
level and 1% for each 10° F (5.6° C) above 77° F (25° C). It
should operate satisfactorily at an angle up to 15° .
14