Craftsman 315.111810 Owner's Manual page 10

_, WARNING: When servicing,use only identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
,_ WARNING: Donot at any time let brake fluids,
gasoline, petroleum-based products,penetrating
oils, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken or
destroy plastic.
Only the partsshown on parts list, page 11, are
intended to be repaired or replaced by the customer•
All other parts shouldbe replaced by a qualified
service technician at an authorized servicefacility.
Avoid usingsolvents when cleaning plasticparts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged
by their use. Use clean clothsto remove dirt, dust, oil,
grease, etc.
DO NOT ABUSE POWER TOOLS. Abusive practices
can damage tool as well as workpiece.
_k WARNING: Do not attempt to modifythis tool or
create accessories not recommended for use
with thistool•Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possibleserious personal
injury.
BULB REPLACEMENT
See Figures 8 and 9.
• Loci< switch trigger by placing the forward/reverse
switch in center position.
• Remove bulb cover.
Note: Depress bulb cover and slide forward as
shown by the arrows in figure 8 to remove.
SUDEFORWARD DEPRESS HERE
BULB
COVER
Remove old bulb by lifting it from socket.
For your convemence, a bulb storage area with an
extra bulb has been provided. It is located inside
the end cap on the bottom of your screwdriver.
See Figure 9.
BULB
STORAGE
AREA
TO REMOVE
ENDCAP
MOTOR
HOUSING
EXTRA END
BULB CAP
TO REPLACE
ENDCAP Fig. 9
• Remove end cap by twistingit in the directionof
the arrow as shownin figure 9.
• Position new bulb in socket.
• Replace bulb cover by insertingtab into slot.
• Replace end cap.
BULB
\
SOCKET
Fig. 8
10