Problem Solver; Metal Grease Filters - GE Monogram ZVC30LSS Owner's Manual

Questions?
Use this
problem
solver!
The Problem Solver
Custom Hood Insert
PROBLEM POSSIBLE CAUSE
FAN AUTOMATICALLY , The Sensor feature will automaticall U turn the fan on at the
TURNS ON AND CAN MED setting if cooking temperatures become too hot. The fan
NOT BE TURNED OFF will sta U on for a minimum of 3 minutes and will then turn off when
temperatures cool to on appropriate level.
FAN DOES NOT , A fuse ma U be blown or a circuit breaker tripped. Replace fuse or
OPERATE WHEN reset circuit breaker.
TURNED ON , The power disconnect switch inside the hood ma U be switched off.
Remove the metal grease filters and flip the switch on.
FAN FAILS TO CIRCULATE , Check to be sure the metal grease filters are clean. Clean the metal
AIR OR MOVES AIR grease filters (see the Metal grease filters section). If cleaning
SLOWER THAN NORMAL the filters does not correct the problem, call for service.
FAN KEEPS GOING , The motor is probabl U overheating and turning itself off. This can
OFF AND ON be harmful to the moton Check to be sure the filters are clean. If off
and on cucling continues, call for service.
LIGHT WILL NOT STAY o Use 120 volt, 50 watt halogen bulbs with a GU!O base and make sure
ON HIGH SETTING they are inserted securel U. See the Light bulbs section.
THE HOOD CONTROLS o Disconnect power to the hood bU removing the fuse or turning the
ARE NOT OPERATING circuit breaker off in the home fuse box. Wait 30 seconds to allow the
CORRECTLY hood controls to reset and then replace the fuse or move the circuit
breaker back on.
It is normal for the light and fan buttons to cgcle around through the
settings so that Uou can easil U set the controls to the desired setting.
SEQUENTIAL PRESSES
OFTHE LIGHT OR FAN
BUTTONS WILL
SOMETIMES CHANGE
THE SETTING FROM THE
LOWEST SETTING-TO OFF-
TO THE HIGHEST SETTING,
OR FROM THE HIGHEST
SETTING-TO OFF-TO THE
LOWEST SETTING
WHEN PRESSING THE
POWER ON/OFF BUTTON
TO TURN ON THE LIGHT,
THE FAN COMES ON
INSTEAD
For uour convenience, it is normal for the lights and fan to remember
their last setting when Uou press the Power On/Off button. If Uou
want onlu the lights on, press the "FAN+" (or the "FAN-" ) button until
the fan is off. When Uou power the hood up next time, onlu the lights
will function.