GE AJCS 06 LZ Owner's Manual page 25

Before You CallJbr Service
Problem
Possible Causes What to Oo
The air conditioner
is unplugged
The fuse is blown/circuit
breaker is tripped
Power failure
* Make sure the air conditioner plug is
pushed coinpletely into the outlet.
* Check the house fuse/circuit breaker
box and replace fuse or reset the breaker.
* It power failure occurs, turn the mode
control to OFF.When power is restored,
wait 3 Ininules to restart the air conditioner
/o prevent tripping of the compressor
overload.
* There is a protective time delay (up to 3
minutes) in the heat/cool and heat pump
models. Wait 3 minutes fi)r the air
conditioner to resuIne heating or cooling.
Airflow is restricted
The temperature control
may not be set high
or low enough
• Make sure there are no curtains, blinds
or furniture blocking tim fiont of tim
air conditioner.
• Turn the knob to a warmer or cooler setting.
The coolest setting provides maxinmnl
cooling. The warmest setting provides
maximum heating on models with heat.
The air filter is dirty • Clean the tilter at least every 30 clays.
See tim Care and Cleaning section.
The room may have been hot • When the air conditioner is first turned on
or cold you need to allow time for tim room to
cool down or warm up.
Cold air is escaping • Check for open furnace floor registers and
cold air returns.
• Set the exhaust vent in the closed position.
Cooling coils have iced up • See fleezing up below.
Ice blocks the airflow
and stops the air conditioner
from cooling the room
• Set the mode control at HIGH FAN or
HIGH COOL with tim temperature at a
warmer setting.
25