GE AJCS 06 LZ Owner's Manual page 14

! Peel offd_e backing from tt_e bottom window
gasket.
2 Place tt_e gasket on tt_e stool and over the
brackets, even with tt_e rear edge, sticky side
down.
Bottom window gasket
3 Careflllly slide tt_e empty case into tt_e window
until tt_e holes in tt_e case line up wid_ tt_e
holes in tt_e panel angles.
Case holes
r'- "_
f "_ •
4 Lower tt_e window so it fits behind tt_e panel
tabs. Insert the 4 type A screws through the
holes in tt_e case and into tt_e panel angles,
2 on each side.
Panel k
tabs -
°x'x_ Case [
5 With tt_e window closed, mark where tt_e
window sash meets the case.
6 Peel offtt_e backing from tt_e case top gasket.
7 Hold on to tt_e case, open the window, and
place the gasket along the mark on tt_e case.
Put the gasket on
top of the case
where the window
will close.
NOTES:
* The case should have a 1/8" minimum tilt
toward the outside.
* Be sure the seal gasket and panel gaskets
remain in position and do not roll wid_ tt_e case.
14