GE Monogram ZV750 Owner's Manual page 6

Care and Cleaning
Stainless Steel Hood
Pbr your
sc fety
geff}re servicing or cleaning file unit, switch
power off at the seaMce panel and lock tile
service panel to prevent power flom being
switched on accidentally: If the seaMce panel
cannot be locked, fhsten a mg or prominent
warning label to the panel.
Metal
grease
filter
Clean the grease filter after 30 hours of "on" time.
A signal light will alert you when 30 hours has
passed.
Remove the grease filters and wash then1
either by hand or ill the dishwasher using
non-abrasive soap.
To clean, swish the filters ill hot soap), water or
wash them ill the dishwasheL Do not use abrasive
cleanseas.
NOTE:To remove filters
push them back and
down using the knob.
Front
For proper operation, be sure to
use the lower set of filter holders.
Hood
suq(lces
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless smel santime, use warm sudsy
water or a stainless steel cleaner or polish. Ah,vays
wipe the surface ill the direction of the grain.
Follow the cleaner insm]cdons for cleaning
the stainless smel surface.
To inquire about purchasing stainless smel
appliance cleaner or polish, or m find the location
of a dealer nearest you, please call our roll-free
IIHlIlbeI':
National Parts Center 1.800.626.2002
ge.com
Light bulbs
To change the light bulbs:
1. Remove the trim ring by turning it
counterclockwise.
2. Grasp the bulb on the edges and pull it
straight out.
3. Replace with the same size })tall).
These 12 volt, 20 watt halogen bulbs are
available at specialty lighting stores. Ask for GE
bulb or equivalent: O,20MR16/C/CG40-BAB.