Installation Ins/Rue/Ions - GE EGR2000 Owner's Manual & Installation Instructions

Installation Instructions
Range
I ff you have questions, call 1.800.GE.CARES or
visit our Website
at: ge.com
I
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber
or gas fitter.
• When using ball-type gas strut-off valves, they shall be
tim T-handle type.
• A flexible gas connector; when used, must not exceed
3 feet.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B 149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according to
CAN/CGA-I.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow.
You will find these precautions in the
Important Safoty
Information
section in the front of this manual. Read
them careflflly.
• IMPORTANT - S ,ve these i nstructions
for loc}d electrical inspector's use.
• IMPORTANT - Obsei e all
g overning
codes and ordinances.
• Note to Installer
-
Be sure
to leave these
instructions with the ConsumeL
• Note to Consumer
- Keep these instructions for
flmne reference.
•
Note
- This appliance must be properly grounded.
•
Servicer
- The electrical diagram is in an envelope
attached to the back of the range.
• Skill level - Installation of tiffs appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the insmlleL
• Product failure due
to improper
installation is
not
r
covered under the X_armnty.
PART INCLUDED
Anti-Tip bracket kit
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of this
or any other appliance.
If you smell gas:
Open windows.
O Don't much electrical switches.
Extinguish any open flame.
hmnediately call your gas supplieL
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-blade screwdriver Open-end or
adjustable wrench
Pencil and ruler
Level
Pipe wrenches (2)
(one for backup) Drill, awl or nail
MATERIALS YOU MAY NEED
• Gas line stmt-offvalve.
• Pipe joint sealant or UL-approved pipe flnead tape
with Teflon* that resists action of natural and LP gases.
• Flexible metal
appliance comlecmr (1/2" I.D.)
A 5-foot
length
is recommended for ease of installation
but other
lengths are acceptable.
Never use an old
comlecmr when inst_flling a new range.
• Flare union
adaptor
for connection
m gas supply
line
(3/4" or 1/2"
NPT x
1/2" I.D.)
• Flare union
adaptor
for connection
m
pressure
regulator
on range
(1/2"
NPT x
1/2" I.D.)
•
Liquid
leak demcmr or soapy
wamL
•
Lag
bolt or
1/2"
O.D. sleeve anchor
(for concrete
floors only).
*Teflon: Regismred trademark of DuPont
34