GE EGR2000 Owner's Manual & Installation Instructions page 25

ge.com
The oven door must be closed
®
ffSelfq
Lcleo.J
F-storQ
L Time3
Oto q
L oo3
and all controls set correctly for the cycle to work properly.
How to Delay the Start of Cleaning (on some models)
Youcan set the oven control todelay-start the oven,
clean for a specific length of time and then turn off
automatically.
Make sure the clock shows the correct time
of day.
Follow the directions in the Before a Clean
Cyclesection.
[7] I,atch tile dooL
NOTE: Never force the lamh. If the oven is
too hot, you will not be able to slide the
latch. Allow the oven to cool.
[] Touch tile Serf Clean pad.
[_] Touch
tile + or - pads to set the
Clean Time.
TheCleanTime ispresetfor4 hoursand20 minutes.
You canchangetheCleanTime to any. t imebetween
3 and5 hours, d epending on theamount o f soilin
youroven.If a differentCleanTime is desired, t ouch
the÷ or- padsuntil thedesiredCleanTime is
displayed.
Change theStart timeby.touching the÷ or- pads.
The start timewifl appear in thedisplay.
[]
Touch tile Start/Onpad.
The self-clean cycle will automatically begin
at tt_e time set.
While file oven is self-cleaning, you can
touch the Clock pad to display file time
of day: To return to the clean countdown,
much the Sel[Clean pad.
The oven shuts off automatically when tile
clean cycle is complete, and 0:00 will flash
in tile display.
_-] Slide tile latch handle to tile left as far
as it will go and open the dooL
Touch tile Start Timepad.
To Stop a Clean Cycle (onsomemodels)
Touch tile Clear/Offpad.
Wait until file oven has cooled below file
locking temperature to unlatch file dooL
You will not be able m open the door fight
away unless the oven has cooled below the
locking temperature.
After a Clean Cycle (on some models)
You cannot set tile oven for cooking until
tile oven is cool enough for the door to be
unlatched.
You may notice some white _tsh in the oven.
Wipe it up with a damp clod1 after tile
oveIl cools.
If white spotsremain, r emove themwith a soap-
filledscouring padandrinsethoroughly, with
a vinegar a ndwatermixture.
These deposits are usually a salt residue
dmt cannot be removed by tile clean cycle.
If tile oven is not clean after one clean
cycle, repeat tile cycle.
You cannot set tile oven for cooking until
tlle oven is cool enough for the door
to unlock.
While die oven is self<:leaning, you can
much the Clock pad to displW the time
of day. To return m the dean countdown,
much the Cooking Timepad.
If die sheh'es become hard m slide,
apply a small amount of vegetable oil or
cooking oil to a paper towel and wipe
the edges of the oven sheNes with the
paper towel.
25
w
-g.
rh%
m
w
m w
g
!
m
m
!
!