Installation Instructions - GE DPVH880 Owner's Manual & Installation Instructions

Installation Instructions
[] LEVEL THE WASHER OR DRYER
[] Stand the washer or druer upright. Move it
close to its final location.
[] Make sure that the washer or druer is level
bu placing a level on top. Check side to side
and front to back.
[] Use an open
ended wrench
to adjust the
legs in and out.
Tighten the lock
nut against
the bottom
of the pedestal.
....
NOTE: To minimize vibration, the locking nuts
must be tight.
[] REMOVE SHIPPING SCREWS
Removethe 4 shipping screws on the back side
of the washer.
[] FINALIZE THE INSTALLATION
Refer to the washer or druer Installation Instructions
to complete the installation.
[] REINSTALL THE DRAWER
[] Check to
be sure the
slides are
closed.
[] Slide the
drawer
into the Drawer
opening.
Align the
drawer
supports to the
slides on each
side.
[] Reinstall the original screws into each drawer
slide. Tighten both screws.
[] Open the drawer fullu. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothlu when Uou push
it closed.
45