GE DPVH880 Owner's Manual & Installation Instructions page 22

Installation Instructions
CONNECTING AN ELECTRIC DRYER (cont.)
CONNECTING DRYER USING 3-WIRE
CONNECTION
if required,by
localcode,
installexternal
ground(not
provided)to
grounded
metal, cold
water pipe,
or other
established
ground
determined
by a qualified
electrician,
GreenGround
Ground Strain
Strap Relief
HotWire Bracket
,Neutral Wire
(white) _]
3/4" UL
Recognized
Strain Relief
Cover 3 #10AWG minimumcopper
conductorsor 120/240V30Apower
supplycord kit markedfor usewith
dryersandprovidedwith closed loop
or spadeterminalswith upturnedends
(notsupplied)
1. Turn off the circuit breaker(s) (30 amp) or remove
the drger's circuit fuse at the electrical box.
2. Be sure the drger cord is unplugged from the
wall receptacle.
3. Remove the power cord cover located at the
lower back.
4. Install 3/4 in. UL-recognized strain relief to power
cord entrg hole. Bring power cord through strain
relief.
5. Connect power cord as follows:
A. Connect the 2 hot lines to the outer screws
of the terminal block (marked L1 and L2).
B. Connect the neutral (white) line to the center
of the terminal block {marked N).
6. Be sure ground strap is connected to neutral
(center) terminal of block and to green ground
screw on cabinet rean Tighten all terminal block
screws (3) completelg.
7. Properlg secure power cord to strain relief.
8. Reinstall the cover.
kWARNING -
NEVER LEAVETHE
I
COVER OFF OF THE TERMINAL BLOCK.
22