Table of Contents
Advertisement
Your trim saw has been shipped completely
assembled except for the blade. Inspect it carefully to
make sure no breakage or damage has occurred
during shipping. If any parts are damaged or missing,
contact your nearest Sears Retail Store to obtain
replacement parts before attempting to operate saw. A
blade, blade wrench, rip guide, and this operator's
manual are also included.
,_i
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
APPLICATIONS
(Use only for the purpose listed below)
•
Cutting all types of wood products (lumber,
plywood, paneling).
_
WARNING:
Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
,_k WARNING:
Do not allow familiarity with your
trim saw to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
CHARGING
BATTERY
PACK
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (cutting
followed by recharging) for them to become fully
charged.
TO CHARGE
•
Charge battery pack only with the charger and
charging stand provided.
•
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charging stand. Align raised
rib on battery pack with groove in charging stand.
See Figure 1.
•
Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in
charging stand.
•
When properly connected, the red light on charging
stand will turn on.
•
Note: If charger does not charge battery pack, return
battery pack, charger and charging stand to your
nearest Sears Repair Center for electrical check.
•
After normal usage, 3 hours or less of charging
time is required to fully recharge battery pack.
Note: If battery pack is completely discharged, 6
hours or longer of charging time is required to fully
recharge battery pack.
•
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
•
When batteries become fully charged, unplug
charger from power supply.
9
Advertisement
Table of Contents
