Table of Contents
Advertisement
TO BEVEL
CUT
The angle of cut of your saw may be adjusted to any
desired setting between zero and 50 ° . Note: When
making cuts at 50 °, blade should be set at full depth of
cut.
When making 45 ° bevel cuts, there is a notch in the
saw base to help you line up the blade with the line of
cut. See Figure 18.
BEVEL
BEVEL
SCALE
ADJUSTMENT
BLADE
GUIDENOTCH
GUIDELINE
ALIGNINNER BLADEGUIDENOTCHONSAW BASEWITH
LINE OFCUT ASSHOWNWHENMAKING45° BEVELCUTS
Fig. 18
Align your line of cut with the inner blade guide notch
on the saw base when making 45 ° bevel cuts.
Since blade thicknesses
vary and different angles
require different settings, always make a trial cut
in scrap material along a guideline to determine
how much you should offset the guideline on the
board to be cut.
When making a bevel cut hold your saw firmly with
both hands as shown in figure 19.
LOWER
BLADEGUARD
Fig. 19
Rest the front edge of the base on the workpiece.
Depress the lock-off button and squeeze the switch
trigger to start your saw. Always let the blade reach
full speed, then guide your saw into the workpiece.
,_
WARNING:
The blade coming in contact with
the workpiece before it reaches full speed could
cause saw to "kickback" toward you resulting in
serious injury.
After you complete your cut release the trigger and
allow the blade to come to a complete stop. After the
blade has stopped, lift your saw from the workpiece.
TO ADJUST
BEVEL
SETTING
• Remove battery pack from saw.
,_
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
•
Loosen bevel adjustment knob. See Figure 18.
•
Raise motor housing end of saw until you reach
desired angle setting on bevel scale. See Figure 18.
•
Tighten bevel adjustment knob securely.
,_
WARNING:
Attempting bevel cut without knob
securely tightened can result in serious injury.
16
Advertisement
Table of Contents
