Warranty Information; Safety Instruction For Scroll Saws - Craftsman 113.23611t Owner's Manual

THIS WARRANTY APPLIES ONLY WHILE THiS PRODUCT IS USED IN THE UNITED STATES.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
SEARS, ROEBUCK AND CO., D1817WA Hoffman Estates. IL 60195
safety instructions for scroin saw
Safety is a combination of common sense, staying alert
and knowing how your scroll saw works. Read this
manual to understand this saw.
BEFORE USING THE SAW
WARNING: To avoid mistakeS that cou|d cause
sertous, permanent Injury, do not plug the saw in
until the following steps ere completed.
• Assembly and alignment. (See pages 8 - 12)
= Learn the use and function of the speed control ON-
OFF knob, bevel lock knob, blade holders, blade
support, hold down tension knob, and blade guard.
(See pages 13 - 14)
Review and understand all safety instructions and
operating procedures in this manual.
Review of the maintenance methods for this saw.
(See page 18)
- Put the saw on a firm level surface where there is
plenty of room for handling and properly supporting
the workpiece
- Support the saw so the table is level and the saw does
not rock.
• Bolt the saw to the work surface if ittends to slip, walk,
or slide during operations like cutting long, heavy
boards, or when using an auxiliary table.
- NEVER STAND ON TOOL. Serious injury could
occur if the tool tips or you accidentally hit the cutting
tool. Do not store anything above or near the tool
where anyone might stand on the toot to reach them.
To avoid Injury or death from electrical shock:
- GROUNDTHE SAW. This saw has an approved 3-
conductor cord and a 3-prong grounding type plug,
Use only 3-wire, grounded outlets rated 120 volts, 15
amperes (amps). The green conductor in the cord is
the grounding wire. To avoid electrocution, NEVER
Read the WARNING label; below, found on the base of
the saw.
WHEN INSTALLING OR MOVING THE
SAW
AVOID DANGEROUS ENVIRONMENT. Use the saw in
a dry, indoor place protected from rain. Keep work area
well lighted.
To avoid injury from unexpected saw movement:
- Turn saw off and unplug cord before moving the saw.
....... green wire to a live terminal.
• Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the saw.
BEFORE EACH USE:
Inspect your saw.
DISCONNECTTHE SAW. To avoid injury from acciden-
tal starting, unplug the saw, turn the switch off and
remove the switch key before changing the setup, re-
moving covers, guards, or blade.
WARNING