Removing And Installing Blades - Craftsman 113.23611t Owner's Manual

removing and installing blades
WARNING: TO avoid Injury from accidental start- I
ing, always turn switch OFF_ and remove switch
key before removing or replacing the blade.
1. Loosen tension on blade by turning tension knob
counterclockwise (F'_) about two full turns.
TENSION KNOB
2. Remove blade by pulling forward on blade and then
liftingthe blade through the access hole in the table.
Slight downward pressure against the upper arm may
be helpful when removing blade from upper holder.
SLIGHT PRESSURE HERE
BLADE GUARD REMOVED
FOR PICTURE CLARITY
3, Look at the blade holdersclosely and notice the blade
slots and pin recesses in the blade holder. The blade
holder is made so you can position the blade for
cutting from the front or one side of the saw.
Cutting from the side of the saw will be necessary
when your workpiece exceeds 16 inches in length.
For 0 ° bevel angle only.
\
\
\
• 10