Advertisement
INSTALL C HUTE M OUNTING BRACKET
NOTE: I fyourmower isequipped witha
sp'ring l oaded d ischarge guard, s kip
ahead to
"TO ASSEMBLE GRASS
CATCHER".
1. Line up the holes of the chute mount-
ing bracet with the holes in the
discharge chute of your mower.
NOTE: Be sure the arms of the chute
mounting bracket point away from the
mower as shown.
2. Attach chute mounting bracket to
mower using (2) two 1/4-20 x 1/2 truss
head machine screws and Iocknuts
and tighten secure}y,
CAUTION:
Do not operate lawn
mower without the discharge guard or an
approved grass catcher in place.
-_1/4-20
hex nuts
Chute
mounting
_.
bracket
1/4-20
truss head
machine screws'
TO ASSEMBLE
GRASS
CATCHER
1. Insed the short leg of the upper
support tube into the seam sewn in
the grass catcher.
2. Continue pushing the grass catcher
onto the upper support tube until the
grass catcher is completely on the
short leg of the upper support tube.
Spread grass catcher evenly around
the upper support tube, leaving the
ends of the upper support tube
exposecl as shown.
3. Insert one of the side tubes through
the lower mouth opening of the grass
catcher, dimpled end first, and attach
side tube to upper support tube.
Repeat on other side of grass catcher
with remaining side tube, leaving the
ends of side tubes exposed as shown.
4. Attach the grass catcherframe to the
exposed ends of th_ side tubes.
5, Slip vinyl bindings over frame,
NOTE:
If vinyl bindings are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before using.
6. Close the flip lid. Flip lid must be
closed while operating lawn mower.
Short leg of
-
Seam of
upper
_
.
grass
support
tube
Exposed end
of upper
support tube
Frame _//7
_'_
f.,_p_,,_
Exposed
5
Advertisement
