Frigidaire FRS12PYW10 Use & Care Manual page 13

Connective pipe and drainage installation
Connective pipe
1. For the left-hand and right-hand
piping, remove the pipe cover from
the side panel. The pipe cover
must be kept as it may be used
when relocating the air conditioner
to any other place.
.
For the rear-right-hand and rear-left-
hand piping, install the piping as
shown in the sideward figure. Bend
the connective pipe to be laid at
a height of 1.69" or tess from
the watt. Fix the end of the
connective pipe.
Pipe cover Pipe Pipe cover
(right) holder (left)
piping
Right piping _
nRier.anrn right
Riea_ft
piping p p y
Indoor unit Connective
outline pipe
yy ? yyy yyy yyy yy --
ssssssssssii;_
Drainage
1. Run the drain hose sloping
downward. Do not install the drain
hose as illustrated sideward.
.
When connecting extension drain
hose, insulate the connecting part
of extension drain hose with a
shield pipe, do not let the drain
hose slack.
Fastening the Indoor Unit
1, Pass the piping through the hole in
the wall,
2. Put the upper claw at the back of
the indoor unit on the upper hook of
the installation plate, move the
indoor unit from side to side to see
that it is securely hooked.
Do not block
water flow
by a rise.
Do not block
water.flow
Do not put the end
of drain hose into water.
Upper hook \
Lower hook