Craftsman 580.752070 Operator's Manual page 14

,
Select desired ProjectPro® nozzle:
* Fordelicate rinse (lower pressure and higher flow),
for gentb cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc. select yellow
delicate ProjectPro® nozzle.
Forgeneralrinsing (medium pressureand medium
flow), idealfor most atI purposecleaningsuch as
home siding, brick patios,wood decks, drivewaysand
sidewalks,garagefloors, etc., selectorangegeneral
ProjectPro@ nozzle.
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oii stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red max ProjectPro@
nozzle.
4. Pull back on collar, insert selected ProjectPro@ nozzle
and releasecollar. Tug on ProjectPro@nozzle to make
sure it is secureiy in ptace.
5. For most effectivecleaning, keep ProjectPro@nozzlefrom
8 to 24 inches away from cleaningsurface. If you get the
nozzietoo ctose, you may damagethe cleaningsurface.
6. DONOTget closerthan 6 incheswhen cleaningtires.
Hew te Use the HydroFoam
TM
Launcher
The quick-connect on the nozzleextension aliows you to
attach the HydroFoam
TM
launcher. Usethe HydroFoam
TM
launcher to appiy HydroFoam
TM
wash or other project specific
cleaners to heip break down stubborn dirt and grime on a
variety of surfaces.
Fellow these instru_,-tians ta attach the HydrePeam
TM
launcher:
1. Engagetrigger iock oil spray gun.
2. Puli back coliar on quick-connect and puli current
ProjectPro@nozzle off. Store ProjectPro@nozzles in
holder provided on the accessory tray.
3. Puii back on coiiar, insert HyrdoFoam
TM
iauncher and
releasecollar. Tug on HyrdoFoam
TM
launcher to make
sure it is securely in place.
IMPORTANT:Also see the HydroFoam
TM
launcher and wash
instruction sheet for important instructions and uses.
Cteanin9 and Applyin9 Detergent
injury, and/or property damage.
NEVER usecausticliquid with pressurewasher.
UseONLYpressure washersafedetergents/soaps. Followall
rnanufacturers i nstructions.
l"e apply detergent fallow these steps:
1. Attach one of the detergent siphon hoses following
instructions Attach Oetergent Siphon Hose to Pump.
2. Review ProjectPro® nozzle and HydroFoam
TM
launcher
use.
3. PrepareHydroFoam
TM
wash according to instructions on
the bottle or prepare detergent soiution as required by job.
4. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
5. If using cleaning tank, pour detergent into cleaning tank.
NOTE:The cleaning tank holds one galIon.
6. Make sure HyrdoFoam
TM
Launcher is instaibd.
NOTE:Detergentcannot be applied with the high pressure
nozzles (Yellow, Orange or Red).
14