Craftsman 580.752070 Operator's Manual page 10

.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
3. Before connecting garden hose to water inlet, inspect
inlet screen. Cleanscreen (A) if it contains debris or have
it replacedif damaged. DO NOTrun pressure washer if
inlet screen is damaged or missing.
.
Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT:DO NOTsiphon standing water for the water
supply. Use ONLY cold water (less than 100%).
5. Connectgarden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE
Using a One Way Valve (vacuum breaker or check valve)
at pump inlet can cause pump or inlet connector damage.
ThereMUSTbeat leastten feet (3 rn) of unrestricted garden
hosebetween the pressure washerinletandany' d evice,suchas
a vacuumbreaker o r checkvalve.
Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty,
6, Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
WARNING
IRisk of eye injury.
_Spray can splash back or propel objects.
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
Checklist Befere Starting Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Be sure to read Safety Ru/'esand Operationsections
before using the cleaning system.
2. Make sure handle is in place and secure.
3. Checkthat oii has been added to proper level in engine
crankcase.
4. Add proper fuel to fuei tank.
5. Checkfor proper hose connections (high pressure and
water suppiy) and that there are no kinks, cuts, or
damageto the higil pressure hose.
6. Provide proper water supply (not to exceed IO0°F).
10