Postscript Error Occurs If A Banner Page Is Printed90; Ethertalk; Not Identified By The Chooser And The Setup Utility; Netbeui - Olivetti d-Color P20W Network User's Manual

P S
OST CRIPT ERROR OCCURS IF A BANNER PAGE IS PRINTED
A PostScript banner page cannot be printed in NetWare 3.12
Remote Printer mode. If a PostScript printer is used and a banner
page is printed, PostScript error is displayed. Turn the banner
output Off in the client's printer settings.
E T
THER ALK
N
OT IDENTIFIED BY THE
Turn the printer off for 15 seconds and then on again.
Check the network cable is correctly connected.
Change the cable and try again.
If the network resides in a zone, check the correct zone name is
selected in the Chooser.
Check the zone name in the utility related to the NIC is the same
as the zone name set in NIC.
Check AppleTalk, which is displayed at the right bottom of the
Chooser, is set to Enable. (In some OS versions Network is used
instead of AppleTalk.)
Check Ethernet is selected in AppleTalk. (In some OS versions
Network is used instead of AppleTalk.)
Check the printer driver is selected in the Chooser.
Check the EtherTalk protocol is set to Enable.
Print the NIC settings and confirm that the EtherTalk port name
is not blank.
N BEUI
ET
The network interface card is not identified.
Turn the printer off for 15 seconds and then on again.
Check the network cable is correctly connected.
Change the cable and try again.
Check Microsoft Network Client and NetBEUI have been added to
the network section of the Windows Control Panel.
C
HOOSER AND THE
Troubleshooting> 90
S U
ETUP TILITY