To Removeand Replacewarmer Drawer; Storage Drawer; Changing Oven Light - Frigidaire CFES367DC4 Use & Care Manual

Genera[ Cleaning
(continued)
To Remove and Replace Warmer Drawer (some
Pull up latch
with finger
Pull down latch .......................................................................................................
with finger Right Glide
models)
To remove Warmer Drawer
1. Turn power off before removing the warmer drawer.
2. Open the drawer to tile fully opened position.
3. Locate the latches on both sides of the warmer drawer.
4. Pull up on the left glide latch and push down on the right glide latch.
5. Pull the drawer away from the range.
6. To clean warmer drawer, gently scour with a soapy scouring pad, this will
remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If
necessary, (:over difficult spots with an ammonia-soaked paper towel for 30
to 40 minutes. Rinse with clean water and a damp cloth. Remove all
cleaners or the porcelain may become damaged during future heating. DO
NOT use spray oven cleaners on the cooktop.
To Replace Warmer Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the
drawer.
2. Push the drawer back into the range,
_ Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric power
before cleaning and servicing the warmer drawer.
Storage Drawer (some models)
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate cleaning under the range. Use
care when handling the drawer.
To open the storage drawer, push the drawer in gently and it will spring open. To close, push the drawer until you hear a click,
which indicates that tile spring is compressed, and the drawer is closed.
Frame
Roller
Roller
Guide
Storage
Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the
roller guide stop, and push in.
Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing tile oven light bulb. Do not turn the oven
light on during tile self<leaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when tile oven door is opened,
Tile oven light may be turned on when the door is closed by using the oven light switch located on the control panel.
On a self (:lean oven the lamp is covered with a glass shield held in place by a wire holder.
THS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN tS tN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1. Turn tile power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self<leaning oven, press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
24