Table of Contents
Advertisement
Available languages
Available languages
MAINTENANCE
Proper maintenance of the Range Hood will assure proper performance
of the unit.
Grease Filters
The grease filters
should be cleaned frequently.
Use a warm detergent solution. Grease filters are dishwasher
safe.
See "INSTALL FILTERS" section for removal and installation instructions.
Non-Ducted
Recirculation
Filter
The non-ducted recirculation fitter should be changed every 6 months.
See
"INSTALL FILTERS" section for removal and installation instructions.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional
care will help preserve its fine appearance.
Cleaning tips:
® Hot water with soap or detergent is all that is usually needed.
® Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
® For discolorations
or deposits that persist, use a non-scratching
household
cleanser
or stainless steel polishing
powder with a little water and a soft cloth.
•
For stubborn cases, use a plastic scouring pad or soft bristle brush together with cleanser and water. Rub lightly in
direction of polishing lines or "grain" of the stainless finish. Avoid using too much pressure which may mar the surface.
o DO NOT allow deposits to remain for long periods of time.
•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing rust.
o DO NOT allow salt solutions, disinfectants,
bleaches, or cleaning compounds to remain in contact with stainless steel
for extended periods. Many of these compounds
contain chemicals
which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
PREPARE
THE HOOD
Unpack hood and check contents.
You should receive:
1 - Hood
1 - Decorative Flue Assembly
1 - Support Frame
1 - Parts Bag containing:
1 - Support Frame Bracket
1 - Discharge Collar
4 - Mounting Screws (6 x 70)
14 - Mounting Screws (3,9 x 9,5ram Pan Head)
2 - Mounting Screws (2.9 x 9.5ram Pan Head)
4 - Washers D.6.4mm
6- Serrated Washers
1 - Wiring Box Cover
1 - Wire Clamp
1 - Installation Instructions
1 - Warranty Card
DECORATIVE
SUPPORT
FLUE
FRAME
DISCHARGE
COLLAR
WIRE
CLAMP
4 WASHERS
D.6.4mm
6 SERRATED
WASHERS
14 MOUNTING
SCREWS (3.9 x
9.5mm Pan Head)
SUPPORT FRAME
BRACKET
WIRING BOX
COVER
¼
4 MOUNTING
SCREWS (6 x
70ram)
_s
2 MOUNTING
SCREWS (2.9 x
9.5ram Pan Head)
"4"
Advertisement
Table of Contents
