Before Setting Oven Controls; Rack Positions; Oven Vent - Frigidaire FGF351SGWC Owner's Manual

Before Setting Oven
Controls
Oven Vent Location
The oven vent is located below the
backguard. When the oven is on, warm
air is released through the vents. This
venting is necessary for proper air
circulation in the oven and good baking
results.
OVENVENT
i!
Arranging Oven Racks
(Some models may have one rack.) ALWAYS ARRANGE OVEN RACKS WHEN
THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts
when using the oven.
REMOVING & REPLACING OVEN
RACKS
To remove, pull the rack forward until
it stops. Lift up front of rack and slide
out. To replace, fit the rack onto the
guides on the oven walls. Tilt the front
of the rack upward and slide the rack
back into place.
ARRANGING OVEN RACKS WITH 5
RACK POSITIONS
To bake on 1 rack, place the rack on
:)osition 3 or 4. To bake on 2 racks,
:)lace the racks on positions 2 and 4.
Setting Oven Controls
Note: The oven control has a built-in [
safety feature that will shut off the
oven if the control is left on for more
than 11 hours 59 m nutes.
To Set or Change the Temperature for Normal Baking
The oven can be programmed to bake at any temperature from 170°F to 550°F
(65°C to 287°C).
To Set the Controls for Normal Baking:
1. Turn Temperature Control Knob to the desired baking temperature.
_f_ST_T_. If _ is not pushed, the control will beep as a
2. Push
reminder.
3. The oven will begin heating to the selected temperature. When the
temperature reaches the desired baking temperature, the control will beep
3 times.
4. To cancel the baking function, turn Temperature Control Knob to OFF.
To Change the Oven Temperature after Baking has Started:
Turn Temperature Control Knob to the new, desired temperature.
If the Power is Interrupted During a Bake Cycle:
Figure 1--Press _ to resume cooking.
Figure 2--Set clock to time of day, then press _.
9