Avoid Service Checklist - Frigidaire FGF351SGWC Owner's Manual

Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrencesthat
are not the result of defective workmanship or materials in this appliance.
This oven isequipped with a state of the art electronic oven controller. Among its many features isa full time oven circuit
diagnostics system.The controller constantly monitors its internal circuitry aswell as several crucial oven circuitsto insure
they are all operating correctly. If at any time one of these systems fails, the controller will immediately stop operation,
and beep continuously (flashing an error code of F1 or F3* in the display window, if equipped).
OCCURRENCE
Range is not level.
POSSIBLE CAUSE/SOLUTION
Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust
leveling legs at base of range until the rack is level. When range is level, cooktop may
appear out of alignment if countertop is not level.
Weak, unstable floor. Besure floor is level and can adequately support range. Contact
a carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Besure cabinets
are square and have sufficient room for range clearance.
Cannot move appliance easily. Appliance Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
must be accessible for service, problem.
Contact builder or installer to make appliance accessible.
Carpeting interferes with range. Provide sufficient space so range can be lifted over
carpet.
Gas line is hard-plumbed. Have a flexible A.G.A./C.G.A. approved metal appliance
connector installed.
*Oven control beeps continuously with no
indicator lights flashing. (If model is
equipped with a display, F1 or F3 will
show.)
Electronic control has detected a fault condition. Turn the Temperature Control Knob
to OFF, and disconnect the power to the range. Wait 30 seconds and reconnect the
power. If fault recurs, disconnect the power and contact an authorized servicer.
Surface burners do not light.
Surface Control knob has not been completely turned to UTE. Push in and turn the
Surface Control knob to LITEuntil burner ignites and then turn control knob to desired
flame size.
Burner ports are clogged. Clean burners. See "To Clean the Contoured Well Areas,
Burner Cap Assembly, Trim Ring (some models), Burner Pan (some models) and Burner
Base' under General Cleaning. With the burner off, clean ports with a small-gauge
wire or needle.
Range power cord is disconnected from outlet (Electric Ignition Models only). Be sure
cord is securely plugged into the outlet.
Electrical power outage (electric ignition models only). Burners ca n be lit manuaTly. See
Setting Surface Controls in this Owner's Guide.
Surface burner flame burns half way Burner ports are clogged. With the burner off, clean ports by using a small-gauge wire
around, or needle.
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.
Surface burner flame is orange.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
In coastal areas, a slightly orange flame is unavoidable due to salt air.
18