Setting the Clock and
Minute
Timer
(if equipped)
For a silent control
panel
(Figure 2 Only):
When choosing a function, a beep
will be heard each time a pad is
pushed. If desired, the controls can
be programmed
for silent operation.
Push and hold STOP TIME. After 7
seconds, the control will beep once.
This will block the controls from
sounding
when a pad is pushed.
To
return the sound, push and hold
STOP TIME again for 7 seconds until
1 beep is heard. Note: The control
will return
to the audible mode after
a power outage.
To Set the
Clock (Figure
2 Only)
When the range is first plugged in, or when the power supply to the range has
been interrupted,
the display will flash "12:00".
I.
Push _'_.
2.
Within 5 seconds, push and hold _'_
or _
until the correct time of day
appears in the display.
Note: The clock cannot be changed during any timed bake or self-clean
cycle.
To Set the
Minute
Timer
1.
Push _.
2.
Push _
to increase the time in one minute increments. Push and hold
_to
increasethe time in 10 minute increments. The timer can be set for
any amount of time from 1 minute to 11 hours and 59 minutes.
you push _
first, the timer will advance to 11 hours and 59
Note:
If
minutes.
3.
The display shows the timer
count down in minutes until one minute
remains. Then the display will count down in seconds.
4.
When the set time has run out, the timer will beep 3 times. It will then
continue to beep 3 times every 60 seconds until
is pushed.
Note:
The minute timer does not start or stop cooking. It serves as an extra
timer in the kitchen that will beep when the set time has run out. The minute
timer can be used alone or during any of the other oven functions. When the
minute timer is in use with any other mode, the minute timer will be shown in
the display. To view other functions,
push the function pad for that mode.
To Change the Minute
Timer
while it is in use:
While the timer is active and shows in the display, push and hold _'_
or _-_
to increase or decrease the time,
To Cancel the Minute
Timer before the set time has run out:
Push _.
Need help?
Do you have a question about the FGF351SGWC and is the answer not in the manual?
Questions and answers