Frigidaire REG94BL Owner's Manual page 7

OVEN
ON
OVEN 0
OFF
OVEN
LIGHT
SET KNOB--Used along with the function pads to select
oven temperature, cooking time, stop time (when program-
ming an automatic stop time), time of day, clean time and the
minute timer. After touching one of the function pads, turn
the knob in a clockwise direction until the desired time or
temperature appears in the display.
OVEN ON/OFF and OVEN LIGHT SWITCH--Used to
turn the oven light and power to the oven on and off.
(The OVEN ON/OFF switch can be used as a power safety
switch to shut off power to the oven when leaving the home
unattended for extended periods of time.) The switch MUST
be in the OVEN ON position in order to program the
oven. The switch should only be turned to the OVEN OFF
position when the oven will not be operated for an extended
period.
The oven can be programmed to:
• Bake conventionally
• Time bake with automatic on and off times
• Broil
• Self-clean
All functions are entered by first touching the appropriate
function pad, then turning the SET knob to select the time
and/or temperature.
If you touch the wrong pad, touch the CANCEL pad. This
will erase all information previously entered except the time of
day.
At the end of any cooking function, touch CANCEL to clear
the display.
For a silent control panel:
When choosing a function, a beep will be heard each time a
pad is touched. If desired, the controls can be programmed
for silent operation. Touch and hold the CANCEL pad. The
control will beep twice. This will block the controls from
sounding when a pad is touched. To return the sound, touch
and hold the CANCEL pad again until one beep is heard.
NOTE: This oven is equipped with a state of the art electronic
oven controller. Among its many features is a full time oven
circuit diagnostics system. The controller constantly monitors
its internal circuitry as well as several crucial oven circuits, to
insure they are all operating correctly. If at any time one of
these systems fail, the controller will immediately shut down
operation; beeping and flashing an error code of -FI- thru
-F10-, in the display window. If this condition should arise,
simply push the CANCEL pad and contact your local author-
ized service agent. 7