Table of Contents
Advertisement
Break-in Procedures
Serious damage may result if the following
break-in instructions
are not closely fol-
lowed.
This procedure
is required only once, before the air
compressor is put into service.
1. Set the pressure switch lever to the "OFF" position.
2. Plug the power cord into the correct branch circuit
receptacle.
3. Turn the regulator clockwise (or open the shut-off
valve), opening it fully, to prevent air pressure build-
up in the tank.
4. Move the pressure switch lever to "ON/AUTO". The
compressor will start.
5. Run the compressor for 30 minutes. Make sure the
regulator, or shut-off valve, is open and there is no
tank pressure build-up.
6. After 30 minutes, close the regulator by turning it
counterclockwise
or close the shut-off valve by turn-
ing the knob clockwise. The air receiver will fill to cut-
out pressure and the motor will stop. The compres-
sor is now ready for use.
OPERATING PROCEDURES ..............................................
!
Daily Start-Up Checklist
Perform the following checks before starting the com-
pressor outfit.
1. Make sure that nothing is blocking the belt guard air
openings or air filter opening.
2. Pull the ring on all safety valves to make sure the
valves move freely and smoothly.
3. Check the oil level; add oil if necessary.
4. Clean or blow off fins or any part of compressor that
collects dust and dirt. Compressor will run cooler
and provide longer service.
Start the compressor outfit and check the following:
1. With the outlet valve closed, start the compressor
outfit. Allow the outfit to pump up to cut-off pres-
sure.
2. Make sure that all controls are operating correctly.
Refer to "Description of Operation" section of this
manual.
3. Check all line fittings and piping for air leaks. Even
minor leaks can cause the compressor to over-
work, resulting in prematu re breakdown or unsatis-
factory performance.
4. Check for excessive vibration and noise.
5. Check for oil leaks. Correct any leaks found.
12
Compressed
air from the outfit may con-
tain water condensation
and oil mist. Do
not spray
unfiltered air at an item that
could be damaged. Some air operated tools
or devices may require filtered air. Read
instructions
for the air tool or device.
6. Open shutoff valve. Your outfit is ready for use.
When You Are Finished:
7. Set the pressure switch lever to "OFF".
8. Close the shutoff valve.
9. Remove the air tool or accessory.
10. Open the shutoff valve and allow the air to slowly
bleed from the tank. Close shutoff valve when tank
pressure is approximately 20 PSI.
Advertisement
Table of Contents
