How To Usethe Remote Control - Friedrich QuietMaster SS14 Operating Manual

920-090-05 (12-05)
How to usethe remote control*
Figure 5
f
/ ]
TINER OPEF_TION
OlgOll Start 8top
8e[Hn
/
/
f
f
J
To start unit
(_ POWER - Press the POWER button once. The unit
will automatically turn on in the mode and tim speed
it was last left on.
To set mode of operation
COOL - Press the COOL button to automatically
switch the operating mode to COOL.
G
FAN ONLY - Press the FAN ONLY button if you want
to run the fan only. You may want to use this feature
in conjunction with the FRESH AIR/EXHAUST if
you want to bring outside air into the room, or exhaust
stale air. (The FRESH AIR/EXHAUST feature is
located on the front of the air conditioner near the top.
See page 7, Figure 8.)
MoneySaver ® - Press the MoneySaver ® button to
activate the MoneySaver ® feature. MoneySaver ® is
the feature that cycles the fan with the compressor so
that the fan does not run all the time.
To adjust temperature
@ WARMER
- Press the TEMP •
button to raise the
temperature setting.
@ COOLER - Press the TEMP • button to lower the
temperature setting.
To adjust fan speed
@
FAN SPEED - Press the FAN SPEED button to see the
current setting. Press again to change the fan speed.
F1 is the lowest setting (SLEEP SETTING), F2 is low
speed (LOW), F3 is medium (MED), and F4 is high
(HIGH).
To set the hour clock
@ SET HOUR CLOCK - Press SET HOUR once to
see the current clock setting. Continue pressing the
button until you arrive at the current time. MAKE
SURE YOU SET THE A.M. AND RM. PROPERLY.
(NOTE: MINUTES ARE NOT SHOWN ON THE
DISPLAY.) A light will appear in the upper left corner
of the display when the hour is RM.
To set the timer
@
®
®
NOTE: Set the hour clock before attempting to set
timer functions. You can set the timer ON/OFF a
minimum of one hour apart, and a maximum of 23
hours apart.
TIMER START - Press START to view the current
start time for cooling. Continue pressing the START
button until you arrive at the start time you desire. The
start time for cooling will then be set.
TIMER STOP - Press the STOP button. Continue
pressing the STOP button until you arrive at the stop
time you desire. The stop time for coding will then
be set.
TIMER ON/OFF
- Press the ON/OFF
button once
to activate (light on) or deactivate (light off) the
timer. Once the START and STOP times have been
selected, they will remain in memory, and cycle daily
until changed.
NOTE: If the unit is unplugged or the power is interrupted,
the HOUR CLOCK must be reset or the TIMER ON/OFF
functions will not work.
-'I: A Friedrich
RCI wireless remote control can be used to operate all QuietMaster_, Electronic models.